Six Shades of Panther

• 2026-4-1 Replaced old print profiles with a new, more reliable version.
  • Variable layer height has been completely disabled, as it was causing support failures for some users.
  • The Huntress’ ears have been re-sculpted to be a little thicker.

🐾 Six Shades of Panther 🐾

One predator. Six spirits.

Unmistakably fierce. Her silence is broken only when power demands a voice. A predator in the dark, and a warning in the light.
“She doesn’t just move in shadows — she commands them.”

Poised with intense focus, she’s the silent observer. Patient, calculating — the one who sees first and strikes last.
"She doesn’t chase; she waits for you to fall into her shadow."

Mouth open, teeth exposed — this is raw energy and unfiltered fury. A warning and a promise.
"She speaks in thunder. Fear listens."

Relaxed, but not lazy — the calm before the leap. Muscles coiled like springs.
"Still water hides the fiercest storm."

Hunched low, almost blending in — mysterious and unpredictable. You feel her presence before you see her.
"Seen only in whispers. Gone before echoes fade."

Head held high, roaring in dominance. She commands space, and no one dares challenge her.
“Born to lead. Feared by all.”

Powered by Image-to-3D from MakerWorld (https://makerworld.com/makerlab/imageTo3d)

Explore Six Howls of Wolf

If you enjoyed the elegance and stealth of Six Shades of Panther, meet their wild kin Six Howls of Wolf.

A pack of six dynamic wolves, each sculpted with precision and storytelling depth.
🐺 Power meets motion — run with the pack.

View Six Howls of Wolf →

Key Printing Tips:

• Disable “Strength → Detect Thin Wall” → gives smoother, cleaner surfaces on detailed parts.
• Always check the slicing preview in Bambu Studio before starting the print.
• Support removal trick: Cut supports into small chunks first, then gently loosen → they usually pop off cleanly without damage.
• Some plates use lots of supports, if so → for reliable prints use these filament settings:
  • Filament Overrides
    • Z Hop When Retract: 0.6 mm
    • Z Hop Type: Spiral
    • Travel Distance Threshold: 1 mm
    • ✅ Enable Retract When Changing Layer
  • Also, disable these settings in Bambu Studio if Variable Layer height is used:
    • Supports
      • ❌ Disable Independent Support Layer Height
    • Others
      • ❌ Disable Reduce Infill Retraction
    • I’ve found that a 0.15 mm top Z distance works best when printing with variable layer height.

Happy printing! Can't wait to see photos of your prints! If you're scaling, experimenting or encounter any issues, let me know → your input helps the next iteration. Please share your feedback for any rating below ⭐⭐⭐⭐⭐ so we can work on improving, thank you!