Search models, users, collections, and posts
"COMBO" Modular Watering Can, 1-liter capacity
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
Designer
6.7 h
2 plates
Open in Bambu Studio
Boost
21
14
15
1
29
21
Released
Description
Content has been automatically translated.
Boost Me (for free)
If you like my projects and would like to support more, leave a boost. A small gesture that would be very important to me
Are you looking for a watering can model large enough for your houseplants, but the printing bed size of your A1 mini allows you to print only smaller models?
That's why I designed “COMBO”, a watering can that, thanks to its nozzle that screws onto the tank, is suitable for all Bambulab printers!
The features of COMBO are:
- Minimal but very solid design;
- 1 Liter capacity;
- Nozzle that screws onto the tank thanks to a convenient thread;
- Comfortable and resistant handle;
- A small barrier at the top of the tank to prevent accidentally spilling water when tilted;
- Needs only a tiny support under the handle.
Happy printing everyone, I hope you like it!
New nozzle models will be published soon!
WARNINGS!
- When screwing on the nozzle, avoid tightening it too much beyond the end stop! the thread could break;
- avoid leaving water inside the tank to prevent compromising its seal;
- some test models showed a very slight water leak where the nozzle is screwed on. If this happens, it is recommended to apply a sealant or simply put a small piece of insulating tape.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (15)