Timless-Plain switch rocker for Busch-Jaeger

Do you have electrical installation with a older switch range from Bush-Jaeger® at your home that doesn't fit to your modern furnishings?
Are you bored about the everyday same design?
Do you want to bring bright colors in your home?

Just print it for little money!
You can find the whole Timeless-Plain series in my collection.

This timeless plain design fits for most Busch-Jaeger® switch ranges like Reflex SI, art linear®, axcent®, balance®, Duro 2000®, and some more.

You still need the sockets, switches and inserts from Busch-Jaeger®, you can only print the frames, rockers, socket insert coverss and cover plates.

Timless-Plain switch rocker for most Busch-Jaeger® switch ranges

There a two versions of the switch rocker: The smooth one and one with inlay.
At home, I mounted the rockers with inlay. I printed the inlay with fluorescent PLA filament, so I can find the light switches for some minutes after it's just gotten dark.
You can also use the inlay to differentiate between the light switches, or simply to add some color.

Note:

• The switch rocker does not inlude the mounting clip. Take it from the original rocker and clip it on the printed part.
• When you choose the rocker with inlay than you have to print the two plates, “… switch rocker with inlay…” and “… switch rocker inlay…” and glue the inlay from the back side of the rocker in.
• I recommend printing the parts with ASA or ABS, e.g. the bambu ABS GF gives you a nice matte finish.

I frequently receive inquiries about printing problems with various print profiles created by other Makerworld users.

Unfortunately, I have no control over the profiles that other Makerworld users upload to my models (Neither the geometry nor the print settings). 

While these are often well-intentioned, they are not maintained, and the results are sometimes unsatisfactory.

Therefore, I strongly recommend using only the print profiles marked "Designer". I can only provide support for these!