Sunflower Photo & Note Stand
Print Profile(2)
Description
Sunflower holder/stand for small pictures (Instax, Polaroid), notes, or messages. No supports needed, no AMS required. The flower has four petal layers: two in front and two in the back. The photo or note slides between the middle layers, held in place like it's blooming from the center.
The center of the flower is printed separately and must be glued after printing.
Spring is here! :)
--------
Update July 2, 2025:
Added a print profile with the sunflower design for multicolor printing, as requested by a community member.
This assumes the use of AMS. No changes were made to the model itself.
--------
This model was designed for Instax Mini-sized photos (approx. 86 × 54 mm) 🖼️, so it’s small and lightweight perfect for tiny photos, short messages, or card names. For larger photos, it should be rescaled to stay stable and avoid tipping over ⚠️.
🌸 License Notice
Personal use only.
Any commercial use including selling physical products, giveaways, freebies, subscriber rewards, or promotional use requires a Commercial License. A Commercial License is available here: https://bluveriestudio.gumroad.com/
-
Check out my new designs, perfect for a home full of flowers and inspired by nature!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (104)