5.8g video transmission antenna, 45*45mm planar antenna housing

My BR2 eye mask's original planar antenna has been disassembled and reassembled many times, causing the banana antenna to break and the copper foil to lift. Later, I bought a general-purpose 5.8g antenna, but it was too large. I found this 45*45mm planar antenna on a shopping platform for just over 9 yuan. With a "use it until it breaks" mentality, I had a sudden inspiration: why not add a housing? So I spent an entire day designing it. After three revisions, I'm finally satisfied! The accessories require 6 M2*8 screws and 2 M2*10 or M2*12 screws (because I used leftover screws, the specific parameters may not be accurate; if the clamp is stripped, please replace it with a longer screw and add a nut). The default settings are for printing with EasyThreed's PETG; please adjust the printing parameters yourself for other filaments. The model is open-source, but commercial use is prohibited. Thank you!