SIG P226 .40 S&W Magnetic Gun Mount
Print Profile(1)
Bill of Materials
- 60 x 10 x 5 mm Bar Magnets x 6: https://a.co/d/imvt8aT
Description
This is a magnetic gun mount based on my SIG P226 .40 S&W Legion. I'm not positive if other .40 SIG's fit it, but I do know that my P229 doesn't fit. I will make another one for the P229. I have printed this in both PLA & PETG and they came out fine. You can either glue the lower part to the upper part after you install the magnets, or when you screw it down to your vehicle or table it will secure them both together. You will need 6 magnets total, one for each side of the slide, and 4 for the top of the slide. The four you will do two side by side then the other two you will do side by side and stacked on top of the first two. Again, this is based on measurements of my P226 .40 Legion, so I can’t guarantee it will work with others.
https://a.co/d/3ou1MSG
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)