dr!ft sturmkind 1/43 trailer
Print Profile(1)
Bill of Materials
- Sekundenkleber x 1:
Description
I have created a trailer for my dr!ft racer from sturmkind.
Of course, I'm happy to share this with you as well.
So, now a little instruction :)
First, glue the trailer platform to the trailer carrier. Caution!!!! This must be flush-mounted on the rear side so that the small right corners remain free at the rear.
For the middle, I used 1 mm thick wooden strips. However, you can use whatever you want here.
After that, I used 4 rear tires from my d1 racer, aligning them in the wheel cover so that the holes for the axle go through under the trailer. After that, I drilled the holes for the axle. I did this intentionally so that you can also use other rim sizes here.
After the holes were drilled, I glued the wheel cover to the rest of the trailer.
Finally, the ramps must be glued to the holder at the top so that it can be hooked into the platform of the trailer at the rear :)
It's a bit fiddly, but I had fun :)
Boost Me (for free)
I would be very happy about a boost ;)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (13)