Search models, users, collections, and posts
Runcam WifiLink2 Mount
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
5
3
0
0
24
4
Released
Description
A minimal and light mount for the Runcam wifilink2 module, holds the board the camera and the antennas. on the bottom there are also some channels meant to hold the cable slack, antenna holder is spread apart and away from other antennas for the best reception,
No support needed.
printed in light TPU.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)