Search models, users, collections, and posts
Ford Fiesta Mk7 Trunk / Car Boot Cover Bracket
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
39 min
1 plate
Open in Bambu Studio
Boost
86
219
3
5
220
102
Released
Description
I've designed this spare part to replace the broken brackets of my Ford Fiesta MK7's trunk cover.
One of my new brackets consists of two parts which are held together with two M3 x 14 mm screws and nuts. There is no left or right side. The bracket can fit both sides.
Prints best in PETG, ABS or ASA with no supports. Use 4 or more perimeters for good stability. Tighten the screws only finger-tight. Otherwise you may break the piece!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)