Search models, users, collections, and posts
Claw of Scratching +1
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
19 min
1 plate
Scaled: 115%,120%,125%,130%
1 h
1 plate
0.2mm layer, 2 walls, 15% infill - A1 Mini - Single
24 min
1 plate
Open in Bambu Studio
Boost
616
1325
138
35
1.7 k
1.5 k
Released
Description
For when you need to scratch but have bad nails... Like my wife. Now she can't justify the super expensive manicures anymore!
After printing remove the little built-in support between the prongs and file the claw tip a bit if there are any sharp final layer artifacts.
Boost Me (for free)
If you enjoy my designs please consider giving a boost! ❤
If you enjoy my designs and want to sell prints of them, I have membership tiers with commercial license available on Thangs! Also if you want to support me while getting access to all my premium designs, I have a cheap personal tier. Please check out my membership plans! ❤
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (138)