M-ATX open Frame wallmount

Ger:

A frame designed to secure an M-ATX motherboard to a wall or any suitable surface.

Available as a single-piece or two-piece print

(Personally, I affixed the two-piece version to a 2mm aluminum sheet using screws)

The apertures designated for M3 threaded inserts are actually through-holes.

This facilitates the use of longer screws, capable of simultaneously securing both the mount and the motherboard, should the application necessitate it.

Prior to printing, verify compatibility with your motherboard, particularly regarding the versions incorporating support surfaces.

Depending on the motherboard's design, the support surfaces may obstruct solder points or other rear-mounted components.

[Feel free to contact me with any questions, suggestions for modifications, or if you wish to offer your support :D https://www.paypal.com/paypalme/clwmarcy ]

Eng:

A frame for mounting an M-ATX motherboard to a wall or other surface.

Offered as a single-piece or two-piece print

(For instance, I secured the two-piece version to a 2mm aluminum plate with screws)

The holes intended for M3 threaded inserts are through-holes.

This allows for the use of longer screws, enabling simultaneous fastening of both the mount and the motherboard, if needed or as the application demands.

Before printing, confirm compatibility with your motherboard, especially for versions featuring support pads.

Depending on your motherboard, the pads may interfere with solder points or other components on the reverse side.

[Please contact me with any inquiries, suggestions for alterations, or if you'd like to provide support :D https://www.paypal.com/paypalme/clwmarcy ]