Building Brick Head Clicker Fidget Toy LEG0-ish

Thank you for your support! If you like our family's designs - you can sell the physical prints through a paid Patreon membership: 

https://www.patreon.com/c/SpacedOutStudio

Click, click, click - the keyboard switch building brick head clicker toy that's always happy!

This easy-to-print design uses an MX mechanical keyboard switch and consists of just two parts, measuring 48 x 50 mm (2 x 2 inches). The face is printed on top to enable smooth ironing and curved surfaces. The eyes and mouth are recessed by one layer for sharper details, preventing color bleed from ironing. Minimal supports are included to securely snap into the MX keyboard switch.

Assembly:

• Remove parts from the build plate and remove the support. 
• May require minimal cleanup so the cross is fully visible (I had little issues with this)
• Works excellent in Bambu PLA with the supports and only minimal cleanup. 
• Install the MX keyboard switch into the base first!
• Align the direction of the arrows!
• Center the brick head top piece onto the base and hold thumb in the middle of the face and press hard and will pop into place.
• Click to your hearts desire. 

Print highlights:

• About 18 grams and 52 min print from Bambu Studio (hope it's same from Bambu Handy)
• Prime tower and added flush included for Yellow => Black
• Normal snug support with manual feature