1:28 Tweak Station - Print in Place

3d printed RC (1:28 scale) tweak station with print in place hinge and leveling.  Great for setting spring tension left to right to make sure your chassis is balanced.

Asides from the bubble levels, amazon links below, the tweak station is fully 3d printed. Other partially printed options I have seen are effective but require bearings and other hardware that I though unnecessary.  The print in place bearing moves very freely (make sure your filament is dry, especially if using PETG).

To use:

1. Use the side Leveling Bolts to set the Station level left to right
2. Use the top Leveling Bolt to set the Station level front to back
3. Place your car centered on the Station
4. Adjust your chassis as needed to set the hinged bubble level to level

Build Plates:

1. Tweak Station with top layer pause to allow for a filament change if you do not have an AMS (I do not)
2. Tweak Station and Leveling Bolts
3. Leveling Bolts only

Required to complete:  Bubble Levels (10x10x29mm): https://www.amazon.com/dp/B07VTQG17V?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2