AleXariton

0.2mm layer, 2 walls, 15% infill

Great model, but on my X1C with Bambu PLA the density was not enough at 15%. In removing the supports, I managed to break off one oar, the back and front images, part of the sail and the mast! Duh...

ninyule

Super fragile and lots of messed up sections. Even with supports it didn't print well. 

Alien

user_1187814556

LukaVucic

Printed this for my daughter to paint over summer break, came out great.  Thanks for the design!

Nick the Dada

shavery

excellent! was tricky getting the supports off. go slowly. gorgeous longship!

user_2064561255

Nightwizard

supports viel zu dicht und haften zu stark am modell. schadloses entfernen nicht möglich

supports far too dense and stick too strongly to the model. removal without damage not possible

mast viel zu schwach, bricht fast immer ab. ruder ebenso. ruder sind als ständer ungeeignet, hier sollte auch der kiel am boden aufliegen.

eins der schönsten wikingerschiffe, aber leider reine filamentverschwendung. Möglicherweise besser mit härteren filamenten, aber für holz und silk unbrauchbar 

mast far too weak, almost always breaks off. rudder likewise. rudders are unsuitable as stands, here the keel should also rest on the bottom.

one of the most beautiful Viking ships, but unfortunately a pure filament waste. Possibly better with harder filaments, but unusable for wood and silk

Jessy

PolisLBC

cover

IMG_20250402_193308.jpg

IMG_20250402_193255.jpg

IMG_20250402_193334.jpg

IMG_20250402_193328.jpg

IMG_20250402_193344.jpg

IMG_20250402_193313.jpg

plate_1.png

2025-04-03_125927caf7eaf.jpg

Viking ship “Drakkar” in one piece. &nbsp;This model is beginner-friendly. Just the supports are little tricky to remove. Be very careful and patient. &nbsp;

Print Profile(1)

Description

Comment & Rating (21)

License

Remixes (1)

Related Models