Trophy: Fail

This is a remix of an okay trophy presented to me for my hard work at the office.  I found the original model and changed the face and motto to a new sillier trophy.  The original model was a bit complicated so I combined all the parts into a 2 piece model.  

This prints in two pieces to optimize multicolor prints.  

The main base and figure is one print and the placard prints separately.  Filament color is by layer.  I used normal supports and you best be careful taking off the support material because this guy is weak in the knee parts.

I used blue to give the character a sad feel.  The face was painted with an acrylic paint pen.

I glued the placard in place with the finest superglue from the dollar store. 

If you like this trophy then consider these other models:

https://makerworld.com/en/models/1279424-trophy-cool-story-bro#profileId-1307064

https://makerworld.com/en/models/1279556-trophy-u-suck-hard#profileId-1307215