Spinlock for Weights (Barbell/Dumbell) (1 Inch)

I needed a new Spinlock for my 1 Inch weight bar, but the other models that are available did not suit my purposes as they were either too tight or too flimsy. Therefore, I had a go at designing my own from scratch to make the ‘perfect’ one for my needs. 

Spinning on to the bar freely without sacrificing grip strength at the weights was my main goal when designing this part and it turned out exactly as I had anticipated. I have had these spinlocks undergo some fairly rigorous testing and they have endured through all reasonable conditions, even in PLA. As always though, do your own testing and exercise caution when using your equipment. 

The print settings have been thoughtfully prepared to attain a good balance between Quality, Strength and Speed. Therefore, I encourage you to use the supplied 3MF file to ensure optimal results from your print. 

Please follow me for future models. Also, feel free to share your prints, ideas and feedback in the comments and don't forget to rate for your monthly points reward! Thank you for looking and happy printing!