Search models, users, collections, and posts
Sanding Sticks 1.5mm/3mm
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
3.7 h
2 plates
Open in Bambu Studio
Boost
288
1017
60
8
614
446
Released
Description
-1.5mm and 3mm Sanding stick sets-
PETG sanding sticks printed at 100% infill/ .08 HQ on an X1C
These were printed using Kingroon PETG, but I am sure they will print just fine with any other PETG.
I designed these to sand models, the 1.5mm set is flexible to get into the tight areas the 3mm set cannot.
-For use with adhesive sandpapers- *Could possibly use it with non adhesive sandpaper that is finer grit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (60)