Ascending Hat Rack / Shelf Organizer

Needed a hat organizer for my closet shelf, this rack holds 7 hats at an incline so you can see each hat and easily remove/replace when done. 

Was inspired by other hat racks I found, but they held the hats slightly too close together and were difficult to get in/out. This model fixes those issues, at the cost of more filament that is.

Printed using P1S with PLA Matte. 2 walls and 10% gyroid infill. Doesn't need to be too strong, and still weighs enough to hold everything in place. Took 5hr to print and about 280g of filament.

V1 file also available, has a solid base, and no front/back covers, so may be weaker on the hat “prongs”. I like the “boxy” look better myself, but v1 uses about the same filament and time.