Knot elements for a 2V geodesic dome
Print Profile(2)
Description
These models emerged from the quest for a lightweight and economical greenhouse construction.
Once all the parts are prepared, assembling them is a delightful experience.
The pipe ends stretch during assembly and snap satisfyingly into the node elements.
Connections can be released by compressing the pipes—using pipe pliers is recommended.
It is crucial to ensure the correct alignment of struts with the nodes.
It might seem slightly confusing at first, but it works!
By foregoing metal and wood, there are no concerns regarding rust or rot.
Suitable primarily for smaller dome diameters.
Although the prototype has a diameter of approximately 3.2 meters, I would advise against this and suggest staying within the 2-meter range.
When applying a tarp, take care with the sharp pipe ends.
I wrapped the nodes with adhesive tape for this purpose.
Not aesthetically pleasing, but it worked.
I gained considerable insight during this construction process.
Not all good ideas are practically feasible :-)
Enjoy building it.
Documentation (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)