Handheld Gardening Rake - Print in Place

A little gardening cultivator / rake with a total print height of 252mm.

Extra walls and thick walls are recommended for structural support. You basically want the rakes and stem to be solid, except where it is passing through the handle. There, I added negative space to double the walls at it's weakest point, this negative space acts like a bolt securing the two sides together.

Model can be printed in place with no supports at slower speeds, I still recommend using brim to prevent model wobbling. I created some profiles that slow down the speed for the top half to make it easy. But you basically just want to make sure you print the top half as slow as possible to prevent the printhead from knocking the model off your plate, or you can enable sturdy supports and print it as fast as you want.