Airsoft Shotgun Tracer (Acetech Quark) Suppressor

This is a more aggressive looking version of my plain shotgun suppressor, it is designed to hold an Acetech Quark M shotgun tracer module and clamp onto the barrel of a typical airsoft shotgun.

I print the body and cap in eSun PLA+, but the clamp in a softer more flexible filament such as TPU.

To use, insert the tracer unit into the top of the body and screw the cap on, then slide the clamp, prongs outwards onto the end of the barrel, then push the body of the unit over the clamp until it starts to push on the clamp then start to screw anti-clockwise to tighten it as far as it will go. The thread narrows so it should get tighter and be a snug fit.