Spool holder for UP Plus / UP Plus 2 with bearings

Replacement filament spool holder for the UP Plus / UP Plus 2

Clips on instead of original one, filament spool rolls on skate bearings (608).

1. Print holder (on the side) (100% infill, 5 perimeters)
2. Print clip (holes up)
3. Clean support
4. slide 5-7 608 bearings on the middle rod (pay attention rod is fragile you can break it off if you are not careful)
5. clip on the "clip" at the end of the holder
6. clip the holder in place of original one

it holds easily 1.5kg spool of filament and spool rolls smoothly and quietly

NOTE: I added the clipon-large file too, if you are using standard 1kg (65mm width) or 0.5kg (42mm width) spools you can use this clip to also prevent spool from sliding off the holder. the small clip allows for larger 1.5-3kg spools to sit (they are not fully supported but this holder can handle them)

source available on onshape

Print Settings

Printer:

self made

Rafts:

Supports:

Yes

Resolution:

Infill:

100%

Notes: