Pin Wrench for ScubaPro Mk17, 19, 25 regulators
Print Profile(1)
Description
ScubaPro Mk17, Mk19, and Mk25 Pin Wrench:
This is a custom designed C styled Pin Wrench for use with several of the most popular ScubaPro 1st stage regulators. The wrench can be used to remove the Environmental Cap from the Mk17 or Mk19. It can use used to remove or reassemble the Mk25 body as well. The environmental caps do not require much torque or force to remove or reinstall. The Mk25 Body requires a fairly large amount of torque however. Because of this the wrench is strongly built and you need to pay attention to the printing parameters to guarantee strength.
Please refer to the ScubaPro regulator service manual for details on how to use this tool.
You will also need some 4mm steel rods to provide the PIN in the wrench. These are available at low cost on Amazon.
Use a Dremel cutting disk or hack saw to cut off a short length of the steel rod. Cut perpendicular. Make it about 5mm longer than the pin hole in the wrench.
Link: https://www.amazon.com/dp/B082ZPDN3C
Boost Me (for free)
Please send a Boost if you like this model and find it useful!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)