GEPRC Cinelog35 V2 Landing Gear - Free 3D Print Model

Search models, users, collections, and posts

btastic_fpv

Hobby & DIY>RC

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

1 set (4 pcs) - 0.2mm layer, 3 walls, 10% infill

Designer

52 min

1 plate

4.8(5)

Open in Bambu Studio

Boost

140

Released

Description

I recently built my GEPRC Cinelog35 v2 when I noticed that the motors were touching the floor when I was setting the cinewhoop on the ground. I needed a solution for that problem.

I have found a few designs, but none of which I was happy with.

So I came up with my own design, that just comes in at ~2g per feet, so it keeps your whoop clean and lightweight.

The best way to put them in is to slide them in from the side. Apply pressure from inside and outside of the protective cage. Be patient and dont use excessive force.

Have fun!

Comment & Rating (9)

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.