Search models, users, collections, and posts
Round Cake Pop Stand
IP Report
Print Profile(2)
Adaptive layers, 3 walls, 5% infill
Designer
8.8 h
1 plate
higher, two-color, printed round, and Z-seam at the back
10 h
1 plate
Open in Bambu Studio
Boost
329
1007
36
17
690
413
Released
Description
This is a cake pop stand that can be used at festivities. The model is round to be the center piece on a table and can hold up to 31 cake pops where the straws have a maximum diameter of 4mm. The cake pop stand itself is 23 cm in diameter and 11 cm high.
The cake pops are set at a angle of 10 degrees to pop out a bit more.
Recommended print settings:
- 3 or more walls
- Gyroid infill @ 5% or higher. This is to ensure some weight when the cake pop stand is empty on 1 side.
- Adaptive layers to speed up print time whilst guarding quality
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (36)