Windsock bracket 18 inch
Print Profile(1)
Bill of Materials
- For the flag pole swivel x 1: https://amzn.to/4j1c8g4
- The 6mm bolts used for the outer ring x 1: https://amzn.to/3DXU9Iu
- 6mm Nuts x 1: https://amzn.to/4caUYKH
- Main mounting bolt 5mm x 1: https://amzn.to/3XCszXX
- Main mounting nut 5mm x 1: https://amzn.to/42iZfsa
- 6mm bolt from the top brace to the main support x 1: https://amzn.to/3DZideb
- High Quality Windsock 18x72 (pictured) x 1: https://amzn.to/4l6iMDF
Description
This is a pole mounted ring for an 18 inch windsock. It prints on 4 plates. Not compatible with the A1 Mini. Supports are needed. They are defined in the 3mf file.
** V2 main support. I added a new stl for the main support that has additional strength. It is more complicated to get the nut on the main screw with this model but its worth if for the additional support.
Because this is designed to be outdoors, I'd recommend using ASA.
The pole mounted swivel contains a bearing that allows the windsock to rotate easily.
Parts:
1x Pole swivel
4x 6mm x40mm Bolts and nuts for the Outer ring (in stainless steel and washers are recommended)
1x 5mm x 90mm bolt and nut for the mains support from the bracket to the swivel mount
1x 6mm x 45mm for the cross brace between the two side sections and the main support.
1x 6mm x 20 screw for the top cross brace to the main support.
Amazon affiliate links
For the flag pole swivel:
The 6mm bolts used for the outer ring can be found here:
6mm Nuts:
Main mounting bolt 5mm:
Main mounting nut 5mm:
6mm bolt from the top brace to the main support:
High Quality Windsock 18x72 (pictured):
License
Comment & Rating (0)