The Path of Hongmoon Series - Ghost Heaven Sword - Sword Spirit - Blade & Soul (Great hero, you are truly the hope of our water frog clan, croak)

The third installment of the Hongmoon Path series

This one's purely hand-crafted. It's my first attempt at model making, so please be understanding. It came out a bit thin, and the blade tends to wobble. It's sufficient as an ornament, and I'll try to optimize it later (digging a hole)

I recommend scaling up and increasing the thickness. My print settings were XYZ: 1400%, 700%, 700%

It uses a dovetail joint structure, so it assembles firmly. You can add glue for extra security.

I strongly recommend slow printing.

Deep gray filament was used.

Tip: Embedding supports within cubes/cylinders increases support stability and reduces print failures (remember to set their infill separately; the less the better, it avoids material waste).

Precautions

Using a polyurea build plate is strongly recommended to prevent print failures. Glue is also an alternative if you don't have one.

The second plate contains the original model; you can scale and assemble it as you see fit.

This model is for learning, exchange, ornaments, and props. Do not use it for roughhousing; pay attention to safety.

Let's save Hongmoon together!