Hard Ground Golf Tees - Free 3D Print Model

Search models, users, collections, and posts

jdireen

Hobby & DIY>Sport & Outdoors

IP Report

Print Profile(4)

All

X1E

P1S

P1P

X1 Carbon

H2D

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.4nz 0.2mm layer, 3 walls, 15% infill

Designer

2 h

1 plate

4.9(11)

Updated V2 -- 0.4mm nozzle 0.2mm layer, 3 walls, 15% infill

Designer

2.1 h

1 plate

5.0(10)

Updated V2 -- 0.6mm nozzle, 0.3mm layer, 4 walls, 30% infill

Designer

2.8 h

1 plate

5.0(2)

0.6mm nozzle, 0.3mm layer, 3 walls, 50% infill

Designer

2.2 h

1 plate

Open in Bambu Studio

Boost

192

587

612

414

Released

Description

I made these hard ground golf tees for use at the driving range -- featuring an anchor pad, placed under the mat, to keep them from flying off.

I strongly recommend that they only be printed with TPU.

The micro cord I used can be found HERE on Amazon. I also recommend using a little super glue to secure all the knots.

– Updated V2 –

NOTICE: To get the updated version, make sure to select one of the “Updated V2” print profiles. (Maker World doesn't currently allow you to order the profiles or set a default).

I've added new print profiles for a version 2 of these hard ground golf tees. Slight improvements all over, but the most notable is that I enlarged the side tethering hole to better accommodate larger cord diameters. While the micro cord I originally used held up fine, I found that it twisted and tangled too easily. I switched to using an 1/8-inch elastic cord securely fastened with a waxed thread hardened with a bit of super glue. Been using them for several months now, and the improvements have been great!

Note: I've left the original print profiles for anyone who may prefer them :)