Search models, users, collections, and posts
xTool S1 hose adapter on top
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 20% infill
Designer
7.7 h
1 plate
No label/logo - 0.2mm layer, 3 walls, 20% infill
7.2 h
1 plate
Open in Bambu Studio
Boost
156
423
86
73
990
553
Released
Description
Remix so that the air outlet is upwards.
Description of the original
https://makerworld.com/fr/models/51151
Table too short? This adapter allows you to reposition the air hose of the xTool S1 for a smaller footprint!
The airflow is still plenty powerful.
- Need minimal support
- NO additional hardware, M3 screws are included in the S1 accessories.
- Perfect fit
!! The screws just thread into the plastic, don't over-tighten them !!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (86)