Search models, users, collections, and posts
3.5" Domed Post Cap
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 10% infill, Variable Layer Height
Designer
9.3 h
2 plates
11x11cm inner size, ABS 0.2mm layer, 3 walls, 10% infill
10.1 h
1 plate
Open in Bambu Studio
Boost
16
49
15
2
85
45
Released
Description
This is a very simple domed post cap that I was requested to make by my dad. It's 3.5" square with a slightly domed cap. It is actually designed to be filled, sanded and painted so there is some fairly obvious layer lines on the slight curve of the top surface. Variable layer height helps with this but they do not completely disappear. Should fit somewhat snuggly on to a standard 4x4 post (3.5" finished width) and can be permanently attached with construction adhesive if desired. Nothing super special but I figured somebody might find a use for it!
I printed in PLA as I knew it was getting finished and would be indoors. I'd suggest printing in PETG, ABS or ASA if you are going to be putting this outside.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (15)