Double Light Switch Plate Cover With Hooks

I liked this style of hooks, but other designs are only for a single switch plate covers so I made this in Tinkercad.  

• There are 3 styles / profiles of double gang switch plates: 
  • 3 hooks on the bottom 
  • 5 hooks on the bottom

  • 3 hooks near the top.

     

• These are jumbo / oversized (135mm/5.3' wide & tall) plates to cover any blemishes or paint lines around the existing switches.

   

• I have manually painted snug supports on the tops of the switch plate cutouts and at the bottom of the screw hole locations. The ones I tried without supports had some sagging in the switch plate cutouts. Since this is a decorative trim, I believe the supports help it maintain a higher quality of print needed for home decor. 

   

• You'll need to use a deburring tool or another method to clean up the bottom edge of the switch plate where it attaches to the bed when you remove the brim.

If you're looking for a matching single plate with this style of hooks here's one on Makerworld.

If you're looking for a mathcing triple switch plate with this style of hooks here's that on Makerworld.