DND Gelatinous Cube

DND Gelatinous Cube by MZ4250 https://www.patreon.com/cw/mz4250

It prints with easy-to-remove supports and is hollow inside to “swallow” your heroes.

The example in the picture was printed with 5% gyroid infill and angled on the print plate. This way, supports only touch the bottom edges of the cube walls, while the angled filament lines and visible sparse infill add extra dimension to the cube’s otherwise plain surface.

I used Transparent PETG, but obviously, Transparent PLA will be a much easier option.

Use the provided profile for the same setup, or try the 3-wall, zero-infill option if you don’t like visible infill lines.