Knipex Pliers Holder Küpper Pegboard

Knipex Pliers Holder for a Küpper Pegboard.

There are two different holders: one version is for small electronics pliers (115 or 125mm) and one version for medium-sized electrician's pliers like side cutters or combination pliers with a length from approximately 140mm. Each holder accommodates a different number of pliers, depending on their size or width. The holders certainly work with pliers from other manufacturers, but I have only tested them with Knipex pliers.

On a 60x40cm pegboard, you can place 5 holders one above the other and 2 side by side.

For easy removal and to optimize space on the pegboard, the receptacles are arranged at a 45-degree angle. Additionally, there is a small storage compartment at the back of the holder to make good use of the necessary clearance.

The model can be printed with various materials, minimal support is necessary.

Due to the model's geometry, it might tend to warp slightly at the beginning of the print, so good bed adhesion is important. A 5mm brim is already provided, and increasing the bed temperature by 5-10 degrees can also be helpful.

Also check out my other matching holders for a Küpper pegboard:

“Screwdriver Holder for Küpper Pegboard”

“Screwdriver Bit Holder for Küpper Pegboard”

“Makita 18V Battery Holder for Küpper Pegboard”

Tiltable and Removable Drawer for Küpper Pegboard

Crimp Pliers Holder for Küpper Pegboard

Drill Bit Holder 1-13mm for Küpper Pegboard

Battery/Rechargeable Battery Holder and Dispenser for Küpper Pegboard

Customizable Universal Holder for Küpper Pegboard

You don't have a Küpper pegboard but an Ikea or Element System one?

I have also created matching holders for those.

Happy printing!