Beyblade X 4-60 Ratchet Keychain

I remixed a 4-60 Beyblade X ratchet to have a protruding part with a hole in it, where a split ring keychain can be installed.

The parts have been adjusted slightly in size, as they were a very tight fit originally and the assembled ratchet was too hard to switch between left and right mode, and was also hard to install on a blade.

I also remixed a UN bit to simply be used as a plug for the bit hole in the ratchet.

The parts have been orientated in the way that gives them the best look and the most strength.

The model should be printed with a 0.2mm nozzle for best result.

For assembly, you will need either: 2 screws from an original Beyblade X ratchet, or 2 M2x4 Flat Head machine screws from Maker's Supply.