Panda Sense - DIY Panda Touch Temp/Humidity Sensor
Print Profile(2)
Bill of Materials
- AHT20 & BMP280 Sensor x 1: https://s.click.aliexpress.com/e/_oEGixLt
Description
Boost Me (for free)
BTT announces a £xx add on for the Panda Touch - a magnetic Temperature sensor that connects to the back.
** PRINT PROFLE BEING REUPLOADED **
I announce a sub £1 temperature sensor - that does the exact same thing!
Parts Needed:
AHT20/BMP280 Sensor - AliExpress - Less than £1.00 - https://s.click.aliexpress.com/e/_omqAkrd
Sticky Pad
Once you've got the Sensor - you will need to pull the wires out of the jumper - and cut off the clip, so its flush, and doesnt have the clip holding it in - as this doesnt fit in the Panda Touch.
You can then take a pair of pliers and lift the tabs holding the pins into the JST connector, so you can rearrange as below:
You can then tuck this behind the device - and through the port at the top of the Printer - using an adhesive square to hold it.
MAKE SURE IT DOES NOT PROTRUDE TOO FAR - This will cause printhead failures.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (23)