Disney Modular Headband for 5 magnet ears
Remixed by
Copyright Claim
Disney Modular Headband for 5 magnet ears
Remixed by
Boost
51
83
5
Print Profile(1)
0.2mm layer, 6 walls, 20% infill, PETG
Designer
54 min
1 plate
Open in Bambu Studio
Boost
51
83
5
2
92
85
Released
Description
This is a remix of @dressyspider's headband for 5 magnet Disney ears. It adds a bow holder to the middle so that you can either tie or use a clip-on bow.
You will need 10x 3mm x 6mm Magnets for the headband
Comment & Rating (5)
All
Print Profile
0.2mm layer, 6 walls, 20% infill, PETG
Prints good in petg, sturdy enough!
1
Reply
Print Profile
0.2mm layer, 6 walls, 20% infill, PETG
the print turned out great but the headband was way too tight/ small for our 6 year old daughter. the “spikes” on the inside were also a little too sharp or long for her. brilliant idea though!! hopefully bigger sizes will come out.
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 20% infill, PETG
1
Reply
Print Profile
0.2mm layer, 6 walls, 20% infill, PETG
1
Reply
Print Profile
0.2mm layer, 6 walls, 20% infill, PETG
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld