Universal Adjustable Cell Phone WebCam VESA 100 Mount for DroidCam
Print Profile(2)
Description
7/13/2022 - v1.0 - Finally! The initial release. I'm done with the holders that hang on the bezel on my monitor precariously. When I pound the desk after losing the umpteenth match of [insert your favorite FPS game here] I need it to withstand the jostles, bumps, and unfiltered "YEAH RIGHT!" screams.
So, here it is. Fully adjustable to tilt in any direction. I designed it on a VESA 100 monitor, which is the most common size unless you're really sized down. My monitors are 27 inches. I figured I'd give it some height that could take on a 32" (or perhaps taller?) monitor.
My monitor is curved, but, I made sure it would "fit" on a flat-back monitor as well.
The phone-pincher is made of TPU so I can slide all kinds of phones into it. Case? No problem. This phone-pincher piece slides into a little slot at the top of the tilt-ball, so, REMIX YOUR HEART OUT and feel free to make a different one for a different circumstance. You want your 13 inch iPad above your monitor? Frick'n do it (but make sure its sturdy, haha)
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
.20
Infill:
15%
Filament:COEX PLA & TPU Various
Notes:
If you have any questions, drop me a comment.
NOTE: The only one that I'd recommend printing a specific way... is the threaded piece. Check the uploaded pictures. I would definitely print it upright, on a raft or something sturdy, and allow for supports... up to a certain height. That's mostly so it stands upright, not necessarily because it needs supports. đLicense
Comment & Rating (28)