shane sisk

0.12mm 层高, 2 层墙, 15% 填充

正常来说这个位置打印不会出现结构强度不行的问题，如果不行的话我会上传分件

Normally, this location shouldn't present structural integrity issues during printing, but if problems arise I will upload separate parts

修正了一些穿模错误，我是没想到竟然会穿模，玩塔科夫玩傻了，这个照门我倒是挺喜欢用的，毕竟加人机

Fixed some clipping errors, I didn't expect it to clip, I played Tarkov too much, I really like using this rear sight, after all, it adds realism