Search models, users, collections, and posts
GX16-2 Charge Port Cover
Remixed by
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
42 min
1 plate
Open in Bambu Studio
Boost
5
14
0
0
40
26
Released
Description
Remix of Lia's gx16-2 charge port cover for the Funwheel X7. I eliminated the thumb tab that Lia had on there, and I replaced it with a flange that hangs over the rails. This way the plug cover sits a little closer to flush and thus is less likely to get snagged on terrain or ripped out or broken in the event that you roll your board over.
I recommend printing with TPU. 0.08mm layer height.
This will work with any other XR frame using the GX16. Though it is designed with the GX16-2, it may work with the 3 or 4 pin versions as well.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)