Action Figure Footlocker/Case
Print Profile(2)
Bill of Materials
Description
Boost Me (for free)
These models can be a lot of work, so please consider giving a boost to help further the development of models like this, and many more! Also, don't forget to follow me for more work like this too!
[Introduction]
When I was a kid, with my 12" GI-Joes, I had this really awesome footlocker model that I could store my GI-Joes in! Now as an adult, collecting the super awesome GI-Joe Classified figures, I wanted that footlocker again, but classified sized! Ahh, so of course I had to design my own. A little more modern take, but with the same basic elements. A base to store the action figure, and a tray for all those awesome accessories. Obviously this model can be used for more than just GI-Joes, or action figures! you could use it for anything really! Bonus, it's stackable.
There are two sizes included, and with each size there are height variations. The lid/tray are standardized for a given size. I can probably make some more size variations if you need something a little different. Size 1 should fit most of the Classified models, while size 2 can accommodate some of the more accessory rich figures, and it can fit some of the Super 7 TMNT figures!
Size1:
180mm x 80mm
Tray height - 17mm
Figure Cavity Heights - 37mm, 42mm, 46mm
Size2:
180mm x 95mm
Tray Height - 19mm
Figure Cavity Heights - 42mm, 47mm, 52mm, 58mm
[Hardware & Filament]
Featured Filaments:
- Bambu PLA Matte Charcoal
- Bambu PLA Basic Sunflower Yellow
- Bambu PLA Oxide Green Metallic
Hardware:
- 4 x M3x8mm Self Tapping Screws (Designed to specifically fit the Bambu screws)
- 2 x D6x2mm magnets
[Assembly]
Assembly is pretty straight forward. Insert the magnets into the lid. Screw the lid in place, and screw in the two screws that are meant for the magnets in the lid to magnet too. Be cautious not to over-tighten the screws on the lid
-------
If you like my work, consider showing your love by Buying me a coffee. Additionally, if you're looking to sell prints of my design, please check out my Patreon page for more information. Additionally, you can follow me on Youtube for videos covering some of my models, and Instagram.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (75)