LP_Scuba_Hose_Quick_Release_Clip

This is a quick release low-pressure scuba regulator hose clip. This is designed to hold the metal part of the hose, close to the second-stage regulator. It includes a ledge that slides into the gap in the metal piece. This ledge stops the clip from sliding on the hose. 

The clip is primarily used on the long-hose when diving in a side mount configuration. If the long hose is clipped to a D-ring on the diver's harness using a boltsnap (see photo) a quick pull on the regulator or hose unclips the regulator allowing for deployment to an out-of-air diver.

This clip allow allows for connivence clipping of a regulator in other diving configurations, for example: twinset long hose during decompression or a single-tank recreational scuba configuration to help keep regulators from flopping around when not in use. 

This is printed with PTEG-HF at 100% infill. The plan to to also print it in ABS and ASA.