Michael vs Lucifer

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.32mm

The Model is 500x220mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.1mm

I would not recommend scaling the 3MF files unless you are sure you can match the edges correctly. I included the full STL before the cut so you can scale it then cut it using Bambu Studio.
Scale only along the X and Y axis., do not change Z height.

 

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA BambuLab Basic Gray Transmission Distance: 2
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.88mm) swap to Blue Gray
    At layer #13 (1.28mm) swap to Gray
    At layer #17 (1.6mm) swap to Jade White for the rest.