Search models, users, collections, and posts
Fortnite Etched Xbox X/S Controller Faceplate
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.2 h
1 plate
Open in Bambu Studio
Boost
273
518
21
7
602
263
Released
Description
Fortnite embossed xbox series x/s controller faceplate
- Bed adhesion is very important so make sure your bed is clean.
- Supports need to be on.
- The top edge and some of the holes can need a little sanding depending on your print.
- If your buttons don't depress after putting the faceplate on, the hole needs a bit of sanding.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (21)