Search models, users, collections, and posts
Glock 19/45 Gen 5 Magwell
IP Report
Print Profile(3)
0.08mm layer, 6 walls, 15% infill
Designer
3.9 h
2 plates
Magwell Glock 45 (PETG)
2.1 h
1 plate
Magwell Glock 45 (H2D - PLA Support for PETG Print)
2.9 h
1 plate
Open in Bambu Studio
Boost
1496
4239
277
62
4.6 k
2.7 k
Released
Description
Before you print,
use a strong, flexible filament! Gen 5 has a flared frame, a magazine well has to overcome it. If you use brittle or weak materials, they will snap. I've tried Bambu PLA matte to no avail. Overture Super PLA+ and even their normal PLA worked well. Hard TPU should also work. I'm guessing any PLA+ should be fine.
To install, angle the back of the magwell into the frame, then twist the front into the magwell lip. You can optionally secure it with a screw, though it won't come loose by itself—there is a claw in the front gripping the frame.
- 2025-04-03, added fuzzy skin and an extra plate with a somewhat riskier orientation, but few blemishes if it succeeds
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (277)