iPod Classic 7th gen case (not thick case models)
Print Profile(1)
Description
A simple case for the 7th generation iPod classic… I designed this for the 160gb model I have (Model no. MC293 in the about screen) but should fit any of the slim 6th gen models too (I believe 6th gen 80gb and 120gb are slim but early 160gb 6th gen have a thicker case back)…
I used some fairly generic/cheap TPU to print this (Eryone TPU from Amazon)… slowed everything down to around 60mm/s to get decent results…
I have also tried Bambu Labs TPU for AMS but this results is a case that “flexes” enough to get the iPod in but not enough give to get it back out again despite have the infill low and holes in the side of the case so I WOULD NOT recommend using this for the print…
Not tried the new Bambu TPU 90A as yet but will upload a separate profile when I get some to try and assuming the results are ok
The profile has the plate specifically set to be textured as I felt this gives a nice finish and helps with adhesion but forgot to use a glue stick on the plate first to help with the release so bear that in mind :)
If you want to change the plate then reset the override on the plate
I have also added editable text… doing this in the slicer is not the best solution as text manipulation is fairly limited but edit or remove as you feel fit.
I have added a support blocker for the text… the depth is only 0.4mm and TPU supports aren't the most fun but it will print ok if you are dialled in
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)