Search models, users, collections, and posts
Aqara Roller Shade Driver E1 Direct Mount
IP Report
Print Profile(2)
LEFT SIDE - 0.24mm layer, 2 walls, 15% infill, with support
Designer
1.7 h
1 plate
RIGHT SIDE - 0.24mm layer, 2 walls, 15% infill, with support
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
45
168
4
1
117
68
Released
Description
I designes a Modell for my Aqara Roller Shade Driver E1 to put it directly on the Roller Blind.
I have uploaded to Version, one is for the right side from the Roller Blind and the other one is for the left Side. (its only mirrored)
You don't have to use Glue or Screws, after the printjob is done, you can lay your Aqara Roller Shade Driver in the top part and with a little bit tension you can bend the bottom Part in place.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (4)