Search models, users, collections, and posts
Underware - HP USB-C Dock Mount
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
97
365
23
15
364
142
Released
Description
This was created to be able to mount the HP USB-C docking station to the Underware cable management grid. https://makerworld.com/en/models/545105-underware-the-ultimate-cable-management-solution?from=search#profileId-464000
These two pieces are connected with two dovetail joints so that the dock is fit snug and does not slide out in any direction.
I had printed this with PLA Matte black filament & a .4mm nozzle. I also had luck with PETG black during testing.
I currently use this myself and have had no issues with it.
Instructions:
Print both pieces with supports enabled, place dock into one half and then fit the second piece and connect the dovetails.
If you print this, please share a pic!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (23)