Clean Footprint Raspberry Pi Zero Camera Module

Work in Progress - but i post it here if anyone wants to try and suggest modifications!

-Raspberry Pi Zero directly plugged into the P1S USB Port
-To manage to fit the Raspberry Pi in the Upper gutter, the USB cable is directly connected to the GPIO of the Pi. (2 pins : 5V and GND)
-Good Clearance even when the toolhead is on the bottom right corner, even with a PTFE Guide
-Module be held in place by the glass only or with tape
-Camera has a good upper view of the plate
-Camera does not get blinded by the LED Light
-Camera Points inside the enclosure only, no peeking outside the machine
-15cm ribbon cable suggested. (50cm in my photos, but i use that cable for placement tests)

To be made:
Guide for USB cable behind the camera support
Clip to hold the Raspberry pi in place.