Dual BeybladeX launcher & ONLY 1! Ripcord needed - Free 3D Print Model

Search models, users, collections, and posts

Cubic Craftsman

Toys & Games>Other Toys & Games

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 3 walls, 15% infill

Designer

1.5 h

2 plates

4.6(56)

PETG - 0.2mm layer, 6 walls, 25% infill

2.8 h

1 plate

4.8(5)

Open in Bambu Studio

Boost

515

1286

1.4 k

1.2 k

Released

Description

Dual BeybladeX launcher using only 1 ripcord! This will work with the original ripcord but the the inner beyblade will not do the click if you twist too hard and will break the cord teeth, so I designed a ripcord that is a bit longer and has the proper spacing on the teeth to allow the over tightening without damaging the teeth. I have printed it out of PLA and it does work, but would recommend the ripcord to be printed out of PETG for the extra strength.

Also watch your filament, I did find that old, not dried filament was weak at the joints where it starts to angle up from the launcher and could crack when removing launcher, but only found this with old filament that had not been dried in a long time, any new or dried filament I did not have this issue.

dualbeybladexlauncher

beybladeduallauncher

beybladexduallauncher

Comment & Rating (84)

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.