RC stand for 1/10 and 1/8 scale models

This is a stand I designed and have been using for 1/10 and 1/8 scale radio control cars and trucks.  It should work with most 1/10 and 1/8 scale vehicles but I can't say it will work with all (1/8 scale vehicles that are on the larger size for example).   The print consists of four parts for printability and modularity.  Within the bottom section there are trays to store small parts like body clips, wheel nuts, etc.  

Two heights can be made using the different size uprights: 

• the standard uprights result in an overall height of approximately 3.51 inches (89.15mm) 
• the tall uprights result in an overall height of approximately 4.51 inches (114.55mm) 

Assembly is easy, just insert the uprights into the top and bottom pieces and secure with M3 machine screws.  You can use either buttonhead or cap head screws, anything 10mm or longer will work.  There are recesses on the bottom to add felt or rubber discs  for feet, but this is optional (if not doing this you can just leave the print supports in place).  I use 10mm felt discs as shown in the last photo.

I used Bambu Lab PETG-HF for the examples shown.  I would recommend using PETG but if your stand will always be indoors PLA will work fine as well.